Collection: SDS Drill Bits

RONIX × BRO GLOBAL · KSA

SDS Drill Bits — Ronix Saudi Arabia

SDS drill bits are the backbone of every rotary-hammer drilling kit — engineered to take direct hammer impact through the SDS chuck interface without slipping. Ronix offers SDS-Plus (light-to-medium, up to 32mm) and SDS-Max (heavy structural, 16-50mm+) drill bits in carbide-tipped configurations rated for concrete, reinforced concrete, masonry, and natural stone. Lengths from 110mm up to 1000mm for deep anchor drilling.

Best Applications

Anchor hole drilling for HVAC equipment, fire-fighting brackets, electrical fixtures
Cable channel drilling for MEP work in concrete walls and slabs
Through-wall pipe-passage drilling with extra-long bits (400mm+)
Structural anchor work in columns with rebar-cutting carbide tips
Tile-bed removal and chasing channels with chisel bits

Buying Guide — What to Look For

Chuck type (SDS-Plus vs SDS-Max)

SDS-Plus: 10mm shank, fits SDS-Plus rotary hammers, bits up to ~32mm. SDS-Max: 18mm shank, fits SDS-Max hammers, bits 16-50mm+ for heavy work.

Bit diameter (mm)

6-8mm for light anchors. 10-12mm for HVAC and conduit mounting. 14-25mm for heavy anchors. 32mm+ for through-wall pipe passages.

Bit length (mm)

110-160mm for typical anchor drilling. 250-400mm for deep work. 600-1000mm for through-wall and tunnel drilling.

Carbide tip geometry

2-flute standard for general concrete; 4-flute for rebar-rich concrete (cuts through reinforcement without snapping); chisel/spade for material removal.

Flute design

Open-flute (S-flute) bits clear concrete dust faster — drill more before binding. Critical for productivity on long anchor runs.

★ SAUDI MARKET NOTE

Saudi concrete is typically very dense and often rebar-rich. Buy 4-flute carbide tips for structural drilling — 2-flute bits will snap when they catch rebar.

Frequently Asked Questions

How do I know if a bit is SDS-Plus or SDS-Max?

SDS-Plus shanks are 10mm diameter with 2 grooves; SDS-Max shanks are 18mm with 3 grooves. SDS-Plus bits won't fit SDS-Max hammers and vice versa.

How long should an SDS drill bit last?

On 8-12mm carbide bits, expect 200-500 holes in standard concrete before the carbide tip needs replacement or the bit is retired. Rebar drilling and abrasive masonry shorten this significantly.

Do I need 4-flute bits for Saudi concrete?

If your work involves columns, slabs, or shear walls with heavy rebar, yes — 4-flute carbide tips cut through reinforcement without breaking the bit.

What's the longest bit available?

Ronix offers SDS-Plus bits up to 600mm and SDS-Max bits up to 1000mm+ for through-wall and structural penetrations. Special orders available via BRO Global.

Can I sharpen a worn SDS bit?

Carbide tips can be re-sharpened on a diamond grinder, but it's usually more cost-effective to replace once the cutting edge is rounded. Bring worn bits to BRO Global Jeddah for evaluation.

Related Collections

Rotary Hammers Masonry Drill Bits Demolition Hammers